General/Additional Tool Help
Line Speed Test (Depending on your broswer you may need to Right Click - Save As.)
This test is to help you determine the best cut speed for a given material type, thickness, and amperage setting on your plasma cutter. It will cut a small coupon of material with 13 different lines. Each line will be cut at a different speed ranging from 10 inches per minute (ipm) to 130 ipm decreasing in speed 10 ipm per cut line. When this coupon is cut out you can look at the dross accumulation and angularity on the face of the cut to help determine which speed was the best.
Voltage Test (Depending on your broswer you may need to Right Click - Save As.)
This DXF file is run after the Line Speed Test and is only required when running an Arc Voltage Height Control unit. The AVHC unit must be set to Manual mode when running this test. The test consists of 2, 6" long lines spaced approximately .75" apart. Import this DXF into the Driver software at the speed determined by the line speed test.
3D Routing Test (Depending on your broswer you may need to Right Click - Save As.)
This DXF file is meant to be imported into a 3 axis Torchmate machine setup for routing. This is to help understand the basic importing process of the Torchmate Drivers Software.
Pierce Count Guide
This Guide will walk you through setting up the Torchmate Driver Software to Keep track of the amount of times a Plasma On command is encountered. This will assist in keeping track of how long and how much use you are getting out of your torch consumables.
Laser Crosshair Guide using Torchmate Driver Version 4
This guide will help you set up your laser crosshair attachment for your Torchmate table.
TM2 Tube Cutter Configuration Pack for Torchmate VMD
These configurations can be loaded onto the Accumove motion controller to use the side-mount tube cutter on the Torchmate 2 Bolt Together machines. Load the appopriate configuration file for the desired pipe diameter. All of these configuration file names designate the pipe diameter in inches.
TMX Tube Cutter Configuration Pack for Torchmate VMD
These configurations can be loaded onto the Accumove motion controller to use the side-mount tube cutter on the Torchmate X and Torchmate 3 Bolt Together machines. Load the appopriate configuration file for the desired pipe diameter. All of these configuration file names designate the pipe diameter in inches.